| 软化水设备工作流程反洗 |
| 添加时间：2021/11/2 14:38:38 浏览次数： |
| 软化水设备工作流程反洗：工作一段时间后的设备，会在树脂上部拦截很多由原水带来的污物，把这些污物除去后，离子交换树脂才能完全曝露出来，再框格护坡模具 箱体护坡模具 华尔街铜牛 电阻柜 接地电阻柜 电缆保护接地箱 隔离墩模具 化粪池模具生的效果才能得到保证。反洗过程就是水从树脂的底部洗入，从顶部流出，这样可以把顶部拦截下来的污物冲走。这个过程一般需要5-15分钟左右。 Backwashing of working process of softened water equipment: after working for a period of time, the equipment will intercept a lot of pollutants brought by raw water on the upper part of resin. After removing these pollutants, the ion exchange resin can be fully exposed and the regeneration effect can be guaranteed. The backwashing process is that water is washed in from the bottom of the resin and flows out from the top, so that the dirt intercepted from the top can be washed away. This process usually takes about 5-15 minutes |
| 上一页 软化水设备安装维护 |
| 下一页 活性炭具有大量的微孔和巨大的比表面积 |