常用污水处理设备运维要点 |
添加时间:2018/3/30 16:46:46 浏览次数: |
常用污水处理设备运维要点
Main points of operation and maintenance of common sewage treatment equipment
1)、粗、细格栅除污机
1), coarse and fine grille decontamination machine
(a)、维护管理
(a), maintenance and management
a)定时清除格栅所截栅渣。加强汛期巡视,增加除污次数,保证水流畅通。
A) scavenging grille slags at regular intervals. We should strengthen the inspection in flood season, increase the number of pollutant elimination and ensure the smooth flow of water.
b)格栅除污机工作时,监视设备的运转情况,发现故障应立即停车检修。
B) when the grille decontamination machine works, it monitors the operation of the equipment. If it is discovered, it should stop and repair immediately.
c)格栅前遇到大块杂物及漂浮物,及时清捞,以防损坏除污机部件。
C) grille before meeting the large debris and floating debris, timely clean up, to prevent damage to the decontamination machine parts.
d)每次除污机维护、检修工作完毕后及时清理格栅机内外卫生,保持干净。
D) clean up the internal and external sanitation of the grate machine in time and clean after every maintenance and repair work of the decontamination machine is completed.
(b)、安全操作
(b), safe operation
a) 除污机、螺旋输送机、压渣机保养、检修后,检查设备是否具备开机条件。
A) after checking and maintaining the decontamination machine, screw conveyor and slag press, check whether the equipment has the boot condition.
b) 除污机、螺旋输送机、压渣机被硬物卡住或垃圾缠绕时,必须停机后进行处理。
B) the decontamination machine, screw conveyor and slag press must be stopped after being blocked by hard objects or garbage.
c) 检修除污机或人工清捞栅渣时注意安全,并有有效的监护。
C) pay attention to safety and effective guardianship when repairing dirty machines or artificial dredging grate.
(c)、维护保养
(c), maintenance
a)保持除污机及其周围清洁。
A) keep the cleaner and its surroundings clean.
b)细格栅每天清理后墙板,集渣口纤维性垃圾一次。
B) fine grille is cleaned every day, then the wall panels are collected, and the slag fiber waste is collected once.
c)发现除污机的传动链瓣有断裂现象等,立即更换。
C) it is found that the drive chain flap of the decontamination machine is fractured and replaced immediately.
d)除污机、螺旋输送机、压渣机按计划定期检修。
D) the decontamination machine, screw conveyor and slag press are regularly scheduled for maintenance.
2)、进水区、出水区设备
2), inlet and outlet area equipment
(a)、设备管理
(a), equipment management
a) 必须严格执行巡视检查制度,并符合下列规定:
A) we must strictly carry out the inspection and inspection system and comply with the following provisions.
① 注意观察各种仪表显示是否正常、稳定。
First, pay attention to whether the various instruments are normal and stable.
② 轴承温升不得超过环境温度35℃,最高温度不得超过75℃。
(2) the temperature rise of the bearing shall not exceed 35 of the ambient temperature, and the maximum temperature should not exceed 75 degrees.
③ 机械填料压盖处不得有发热异常情况,定期检查油脂泵或自动加油装置的工作情况,以水润滑的填料,滴水不成线。
There must be no fever abnormal situation at the cover of the mechanical packing, and check the working condition of the oil pump or automatic refueling device regularly, with the water lubricated filling, the dripping water is not line.
④ 潜水泵机组不得有异常噪音或震动。
There is no abnormal noise or vibration for submersible pump units.
⑤集水池水位保持正常,检修时不得利用水泵在最低工作水位以下运行水泵,抽排剩水。
5. The water level of the sump is kept normal. During the overhaul, the pump should not be used to run the pump below the lowest working water level and drain the remaining water.
(b)提升泵站的设备应保持良好状态。
(b) the equipment in the pumping station should be in good condition.
b) 保持泵站的清洁卫生,各种使用工具摆放整齐。
B) keep the pump station clean and clean, and all kinds of tools are placed neatly.
及时清除泵体、闸阀、管道的堵塞物。池内漂浮物及时打捞,防止吸入泵体引起堵塞。
Clear the blockage of pump body, gate valve and pipeline in time. The floating parts in the pond are salvaged timely to prevent the blockage caused by the suction pump body.
c) 泵房的集水池一般每年至少清理一次,同时进行相关设备检修。
C) the pump sump is cleaned at least once a year, and the related equipment is overhauled at the same time.
d) 对软启动器及其他附属设备的管理等可按变配电站内容执行。
D) the management of soft starter and other auxiliary devices can be carried out according to the contents of substation. |
上一页 涂装电镀超纯水设备概述 |
下一页 水处理之反渗透设备详解 |